3-2 Chapter 3, Setup Program
3.2 HOW TO RUN SETUP
To run SETUP, follow these instructions:
1. Insert either ADVANCED DIAGNOSTICS or
USER DIAGNOSTICS diskette into drive A.
2. Turn the diskette drive latch to engage
the drive.
3. Turn on the computer and monitor. If the
computer is already on, reset the system.
The system runs POST, counting and
displaying the amount of memory and
checking the various system components.
4. Follow the instructions on the screen as
the program sets the system configuration.
NOTE: The F1 function key can be
used anytime during SETUP to
access HELP.
5. When SETUP is complete, select EXIT and
reset the system.
Addendum 108431-001 (11-88) to
Manual No. 108033-003
To Next Page
Loading...
