Maintenance and Service Guide 7-15
7.8 BATTERY
The battery is secured to the system unit chassis
with a VELCRO strip and is connected to the
system board by a small cable and connector.
Disconnecting the battery removes the time,
date, and system configuration information from
the system memory. Any time you remove the
battery, you must rerun the SETUP program.
WARNING
This procedure is to be performed by Autho-
rized COMPAQ Computer Dealers only.
To remove the battery, follow these steps:
1. Complete the removal procedures in the
following sections:
a. 7.2 MONITOR
b. 7.3 KEYBOARD
c. 7.5 PREPARING THE SYSTEM UNIT
FOR THE INTERNAL REMOVAL
AND REPLACEMENT PROCEDURES
d. 7.6 SYSTEM UNIT COVER AND
INTERNAL CONFIGURATION
To Next Page
Loading...
