7-44 Chapter 7, Removal and Replacement Procedures
Addendum 108431-001 (11-88) to
Manual No. 108033-003
4. Remove the ten mounting screws that
secure the system board to the chassis.
5. Carefully remove the system board from
the chassis (Figure 7-46).
Figure 7-46. Removing the System Board.
To replace the system board, follow these steps:
1. Reverse Steps 1 through 5. Be sure to tight-
en the mounting screws because they
provide proper grounding for the system.
NOTE: When you reconnect the power
cables, refer to the configuration
label on the drive housing assembly
for the location of the connectors.
2. Run the SETUP program.
To Next Page
Loading...
