Compaq DESKPRO 386 - Page 18

xvi
7-9. Removing the System Unit Cover 7-10
7-10. Overhead View of the COMPAQ DESKPRO 386 Personal
Computer with the System Unit Cover Removed 7-11
7-11. Location of the Power Supply Assembly 7-12
7-12. Removing the Power Supply Screws 7-13
7-13. Removing the Power Supply Assembly 7-13
7-14. Location of the Power Supply Connector
on the System Board
7-14
7-15. Location of the Battery 7-16
7-16. Location of the Battery Connector 7-16
7-17. Removing the Battery 7-17
7-18. Removing the Security Lock (Interior View) 7-18
7-19. Location of the Reinforcement Bracket 7-19
7-20. Location of the RF Shield 7-20
7-21. Location of the Cable Cover 7-20
7-22. Removing the ESDI Fixed Disk Drive
Controller Board Signal Cables 7-21
7-23. Removing the Multipurpose Fixed Disk Drive
Controller Board Signal Cables 7-21
7-24. Removing the Fixed Disk Drive
Controller Board Signal Cables 7-22
7-25. Removing an Expansion Board 7-22
7-26. Location of the 80287 Coprocessor Socket on
the System Board 7-23
7-27. Removing the 32-Bit Memory Expansion Board
from the 32-Bit System Memory Board 7-25
7-28. Removing the Memory Chip 7-27
7-29. Inserting the Memory Chip 7-28