Compaq ProLiant 3000 - Page 140

I
ndex -8
For use with 350-MHz or greater Intel processor-based servers only
Writer: Cheri Stewart Project: Compaq ProLiant 3000 Servers Setup and Installation Guide Comments: 179776-002
File Name: K-INDX.DOC Last Saved On: 1/12/99 1:34 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
rack
Continued
mounting hardware 3-8
mounting hardware, illustrated
3-7
server cable management arm
3-26
server safety 3-24
slide rail assembly 3-11
stability warning 3-16
temperature requirements 3-5
template 3-8, 3-16
tools needed for installation 3-9
unpacking the rack server 3-7
Rack Builder Configuration Tool CD
3-1, 3-2, 3-9
Rack Information Library CD 3-9
RAID levels 1-7
rails
assembly 3-10
attaching 3-11
bracket 3-10, 3-11, 3-12, 3-13,
3-14, 3-15
component 3-10, 3-11, 3-12,
3-22, 3-25, 3-26
component, illustrated 3-22
inner slide, illustrated 3-13
rack hardware 3-8
slide 3-8, 3-10, 3-11
slide, illustrated 3-11
RAM See memory
Rapid Recovery 1-5
redundant
fans 1-4
NIC 1-4
power supplies 1-4
SCSI controllers 1-4
regulatory compliance label, location
A-9
removal
drive cage, illustrated 4-15
duplex enable board, illustrated
4-16
hard drive, illustrated 4-23, 4-24
IMD blank illustrated 4-21
media bay face plate illustrated
4-18
power supply plate illustrated
4-28
server cover, illustrated 4-4
requirements
airflow 3-6
power 2-3
power cord set B-1
temperature 2-4
resolution
compatable 1-3
video 1-3
resource conflicts 5-3. See also IRQ
resolving 5-4
ROM 1-5, 5-3, 5-4, 5-13. See also
memory
ROMPaq 1-5, 5-1
S
safety, rack server 3-24
SCO
device drivers
features 5-17
installation 5-17
OpenServer 5-13
OpenServer drivers 5-17
SMP OpenServer 5-14
UnixWare 5-13
UnixWare 2 drivers 5-17