ndex -10
For use with 350-MHz or greater Intel processor-based servers only
Writer: Cheri Stewart Project: Compaq ProLiant 3000 Servers Setup and Installation Guide Comments: 179776-002
File Name: K-INDX.DOC Last Saved On: 1/12/99 1:34 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
sockets
memory 4-1
processor 4-1
Software Support 5-1
Solaris 5-13
spinning bar, IMD 6-1
SRL See Systems Reference Library
storage devices 1-3. See also hard
drives
Support Software 2-6, 5-1, 5-3, 5-4,
5-9, 5-10, 5-15, 5-16, 5-17, 5-18,
5-19, 6-7, 6-8
supportability 5-1
Survey Utility 6-10
viewing IML 6-10
symbols
IMD 6-4
in text x
on equipment x
Symbols in Text x
system
behavior with error events 6-5
creating partition 5-9
management features 1-5
memory See memory
system board 4-1
system board components
floppy signal cable connector
4-5
IDE signal cable connector 4-5
identifying 4-5
locating 4-5
memory slots 4-5
PCI slots 4-5
processor slots 4-5
shared PCI/ISA slots 4-5
system boards
components 4-5
configuring 5-13
features 4-5
features, illustrated 4-5
removing 5-13
switches 4-7
system configuration setting
switches, table 4-7
system configuration switch 4-5
System Configuration Utility 2-6,
5-3, 6-7
menus
configuration backup 5-6
configure hardware 5-6
Diagnostics and Utilities
5-6, 5-20
Operating System
Installation 5-6
Power-On-Defaults 5-6
System Configuration 5-6
system partitions 5-6
starting 5-5
starting SmartStart from 2-6
system features 1-1
system partition 5-6, 5-8
upgrading 5-10
verifying 5-10
Systems Reference Library 1-8
T
tape drives 4-18
Telephone Numbers xii
To Next Page
Loading...
