6-46 l Troubleshooting
Replacing the Desiccant Wheel Motor
D1300 - 5000) (continued)
9 Slip the belt onto the sprocket, and adjust the tension spring nut to its
original position.
10 Connect the wires to the new motor.
11 With the access panel still removed, connect the power to the dryer and start it.
Ensure the wheel turns in the correct direction. If the belt appears to be slipping, it
may be necessary to increase the tension on the drive belt slightly. Do not increase this
tension any more than necessary to allow the wheel to rotate without slipping.
12 Bolt the access panel in place and close the side panel(s) on the dryer.
To Next Page