Using the DeviceNet
Communication Dip Switch Settings
(continued)
Dip switch set 2 identifies the Modbus addresses of controllers connected to the
DeviceNet interface. From one to eight controllers can be enable for communica-
tion through a single Athena DeviceNet interface module.
Dip switch set 2 position 4 identifies the baud rate used to read parameters on
Modbus.
Dip switch set 2 positions 1-2 identify the parameter list for the Conair controllers.
(continued)
C-4 l Dev ice Ne t Commu ni ca tions
To Next Page
Loading...
Need help?
General
