Cleaning the Regeneration Filter
Clogged filters reduce air flow and dryer efficiency. Cleaning frequency depends
on how much material you process and how dusty or full of fines it is.
1 To access the regeneration filter, use a
small flat screwdriver to gently pry
down on the slot in the lower right hand
corner of the filter grill while pulling out
on the bottom.
2 Remove the filter from inside the grill
and clean with soap and water.
3 Replace the filter in the grill and snap
the grill into place.
Maintenanc e l 5-9
5
Maintenance
✐
NOTE: The control cabinet must be securely closed while the dryer is in operation to
ensure that regeneration air is filtered.
CAUTION: Hot surfaces.
Always protect yourself
from hot surfaces inside
and outside the dryer and
drying hopper.
To Next Page
Loading...
Need help?
General
