97
BEFORE LEAVING THE JOB SITE
1) Clean up the work area.
2) Make sure all anchoring bolts/nuts are securely
tightened (ie. rail brackets, rail joints, carriage, pump
unit, and cab bolts/screws).
3) Make sure all controls operate as outlined in “Testing
Operation” section of this manual.
4) Demonstrate the operation of the elevator. During
this orientation, stress the importance of proper
operation and required maintenance.
5) Mount the operation instructions at an appropriate
entrance level.
6) Make sure excess cable has been cut from the clamp
end.
To Next Page
Loading...