Dinverter
A
User Guide
Issue code: d2au9
Notice that the menu and parameter numbers appear at the same time
and the parameter number increases by one. You can repeat this step
as many times as required.
Figure 5–3 Increasing the parameter number (parameter 0.01 is shown)
Scrolling
3 Within eight seconds, press and hold down
Notice that the parameter number continuously increases
(scrolls upward) until the highest numbered parameter in the menu is
reached. To start scrolling upward again from parameter 00 in the
menu, release then re-press:
4 Repeat steps 2 and 3 using
The parameter numbers will now decrease. In step 3, when parameter
00 is reached, releasing and re-pressing the key will re-start downward
scrolling from the highest numbered parameter in the menu.
Select a parameter
5 Using these techniques, select parameter 0.06.
Changing the value of a parameter
1 Within eight seconds of selecting parameter 0.06, press:
The display enters Edit mode.
If more than eight seconds have elapsed, the display will have returned
to Status mode. In this case, twice press:
On the first press, the display will re-enter Parameter mode where
parameter 0.06 will again be displayed; on the second press, the
display will enter Edit mode.
When the display is in Edit mode, it shows the value of the parameter.
The least significant digit flashes, as shown in Figure 5–4. (The value
shown is the default value for 0.06; the value displayed may be
different if the Drive has been used previously.)
To Next Page
Loading...
Need help?
General
