CPS SCA36KTL-DO/US-480 - Power Derating Setup

96
6.2.5 Power Derating Setup
“Power Derating Setup” menu is used to set the active power derating
parameters including Active Power Derating, Over frequency derating,
Low frequency derating, High temperature frequency derating, etc. The
parameters are shown in Figure 6-13.
LVRT/HVRT Setup
Setting
P1/2
System Parameters
Protection Parameters
Power Derating Setup
Reactive Power Derating Setup
ARC Parameters
Control Command
Active Power Derating
Percentage
CtrMode
P1/3
100.0%
0：disable
Reserve
Power vs Grid Voltage
VwCurveV1
P2/3
100.0%
106.00%
Enable
VwCurveP1
VwCurveV2
VwCurveP2
110.00%
0.0%
VwCurveRspTms
10.0
FreqDroop_DbOf
P3/3
FreqDroop_kOf 0.05
0.036Hz
5.0
60
Power vs Grid Frequency
FreqDroop_DbUf
FreqDroop_kUf
FreqDroop_RspTms
FreqDroop_RecTms
OvrFrqDeratingMode
0.036Hz
0.05
Disable
Figure 6-4 Power Derating Setup