6.6 Start-Up
Automatic start-up: The inverter will start up automatically when the
output voltage and power of PV arrays meet the set value, AC power grid is
normal, and the ambient temperature is within allowable operating range.
Manual Power ON/OFF: Manual Power ON/OFF is required after regulation
setting or manual (fault) shut-down. Press ESC to and ENT to access the
Main Menu, move the cursor to “ON/OFF” and press ENT. Once in the
“ON/OFF” submenu, move the cursor to “ON” and press ENT to start the
inverter. Then the inverter will start up and operate normally if the start-up
condition is met. Otherwise, the inverter will go to stand-by mode.
6.7 Shut-Down
Automatic shutdown: The inverter will be shut down automatically when
the output voltage and power of PV modules are lower than the set value,
AC power grid fails, or the ambient temperature exceeds the normal range.
Manual shutdown: Normally, it is not necessary to shut down the inverter,
but it can be shut down manually if regulation setting or maintenance is
required.
Press ESC and then ENT to access the Main Menu. Move the cursor to the
submenu Manual Power ON/OFF and press ENT. Move the cursor to “OFF”
and press ENT, and then the inverter will be shut down.
To Next Page
Loading...
