Cradlepoint CBA850 - Setup Wizards; ECM Registration; Initial Router Configuration

©2015 Cradlepoint. All Rights Reserved. | +1.855.813.3385 | cradlepoint.com
58
User Manual / CBA850
11/5/15
Administrator Password and Time Zone
Enter a password for the administrator who will have full
access to the router’s management interface.
You can use the default password on the back of your
product, or you can create a custom Administrator Password.
Conguring Your Wireless Network
• Wireless Network Name - When you are browsing for
available wireless networks, this is the name that will
be broadcast from this router. This name is also referred
to as the SSID. For security purposes, it is highly
recommended you change the pre-congured wireless
network name.
• Enable Guest Network - If the guest network is enabled,
anyone can connect to the special guest network
which allows limited connectivity to the Internet while
preventing access to your local network.
• Security Mode
• Best (WPA2): Select this option if your wireless
adapters support WPA2-only mode. This will
connect to most new devices and is the most
secure, but may not connect to older devices or
some handheld devices such as a PSP.
• Good (WPA1 & WPA2): Select this option if your
wireless adapters support WPA or WPA2. This is
the most compatible with modern devices and PCs.
• Poor (WEP): Select this option if your wireless
adapters only support WEP. This should only be
used if a legacy device that only supports WEP will
be connected to the router. WEP is insecure and
obsolete and is only supported in the router for
FIRST TIME SETUP
SETUP WIZARDS
ECM REGISTRATION
To register the router
with Cradlepoint ECM
you must rst have an
account. If you need
to create an account
you can signup at
cradlepoint.com.
Once you’ve created
an account, or if you
already have one, you
can enter your ECM username and password to register the router.