CABRIOLE’
CRAMARO TS S.r.l. – 37044 COLOGNA V.TA (VR) - VIA QUARI DESTRA, 71/G TEL. +39 0442/411688 / FAX + 39 0442/411690
E-MAIL info@cramaro.com WEBSITE: http://www.cramaro.com - Manual n° MCA016-EN-ED00 – date 15/01/15
page 50
FIG 80
FIG 82
50
15 mm
FIG 81
229
159
101
15 mm
HOOK DISTRIBUTION DIAGRAM
TYPICAL HOOK CONFIGURATION AND SIZES
- VERTICAL ROLLER HOOKS -
Made for containers with the upper profiles of the sideboards that tend to widen considerably, or "warp," during
loading or for use in the event of wind, they are usually provided based on the length of the container.
The hooking elements to secure to the container must be secured being especially sure that the elements are
horizontal and the securing height is uniform to prevent them from hindering the bows in sliding during
tarpaulin opening and closing operations.
ATTENTION: leave approximately 10-15mm of space between the hook and the slot to prevent the hooks
from getting stuck when opening and/or closing the tarpaulin
HOOK DISTRIBUTION DIAGRAM
To Next Page
Loading...