CABRIOLE’
CRAMARO TS S.r.l. – 37044 COLOGNA V.TA (VR) - VIA QUARI DESTRA, 71/G TEL. +39 0442/411688 / FAX + 39 0442/411690
E-MAIL info@cramaro.com WEBSITE: http://www.cramaro.com - Manual n° MCA016-EN-ED00 – date 15/01/15
page 64
1
2
3
3
1
2
FIG 101
- ROUTINE MAINTENANCE OPERATIONS -
ATTENTION: ALL THE FOLLOWING MAINTENANCE OPERATIONS MUST BE
CARRIED OUT WEARING THE APPROPRIATE HAND PROT
REPLACING THE "TARPAULIN LIFTING PEHD STRIP"
The PEHD strip inserted into the sheet side pockets of the tarpaulin
force the sheet to take the correct shape
during retraction (container opening)
The strip is made of an extremely
sturdy durable material; however, after a
series of working "cycles" that vary depending on the most
diverse conditions of work, it must also be replaced
as it breaks and no longer serves the function for which it
was created and it can be easily replaced.
1) Pulling rope
2) Bow end runner
3) PEHD STRIP
Extend the tarpaulin properly.
After having released it from the fixing screws that keep it anchored
to the ends of every single bow, carefully extract the damaged (or worn) strip and insert
the new strip in the pocket under the lateral section of the sheet.
Therefore, after having carefully made sure that the entire tarpaulin is extended properly, re-
drill the holes on the strip where the previous ones were on every single bow.
Reassemble all the bow ends with the specific washers and nuts that were previously removed and secure the front
part of the strip on the tarpaulin inclined front brackets.
Retract the tarpaulin and make sure everything behaves as it should
N.B. After replacement, PRE-FORM
PRE-FORMING OF THE PEHD STRIP
FOR SHEET LIFTING
REPLACING "THE END PINS OF THE BOWS"
The end pins of the TARPAULIN bows can be easily replaced, even with the
tarpaulin assembled (it is not necessary to remove the tarpaulin from the container )
Loosen the nuts located above the tarpaulin to replace the REMOVABLE PINS and extract the
TWO PARTS of the pin, being careful during reassembly that the parts match up correctly and rest well on the
pressed bow end.
Once you have put the runner screws back into the holes through the sheet and the PEHD strip, properly tighten the
nut and the work is done.
To Next Page
Loading...