Cramaro CABRIOLE - Remote Control Learning

CABRIOLE’
CRAMARO TS S.r.l. – 37044 COLOGNA V.TA (VR) - VIA QUARI DESTRA, 71/G TEL. +39 0442/411688 / FAX + 39 0442/411690
E-MAIL info@cramaro.com WEBSITE: http://www.cramaro.com - Manual n° MCA016-EN-ED00 – date 15/01/15
page 42
4-BUTTON TRANSMITTER KEY functions
A: tarpaulin activation - OPENING
function
B : tarpaulin activation - CLOSING
function
C: VIBRATOR
controlled activation
D: tarpaulin activation - CLOSING
function
(same function as key B)
ADDITIONAL REMOTE CONTROL
(OPTIONAL)
Should you wish to have several REMOTE CONTROLS
to allow several operators to always have their own on
hand, you can also purchase them separately.
In order to be able to use the additional remote
control(s), the control unit must be properly configured
to recognise the signals of the additional remote
controls.
The control unit can be paired with up to 5 remote
controls.
When pairing an additional remote control, the
configuration inside of it related to the previous
configuration is deleted and the new remote control acquires the configuration of the control unit to
which it has been paired
below are the operations to follow to recognise and memorise one or more remote controls.
REMOTE CONTROL LEARNING
Proceed as follows to recognise and save a new remote control:
1. Press the (red) mushroom-shaped emergency button) to switch the device off and wait at least 1
second
2. Release the (red) mushroom-shaped emergency button to switch the device on again
3. Within 3 seconds after start-up, press buttons A and D on the remote control simultaneously (
until the control unit )LED lights up for about 100 ms (wait for about 3 s).
This means that the control unit has entered the learning mode.
4. Release buttons A and D of the remote control and wait at least 1 second;;
within 10 seconds, in the control unit learning mode, activate the save function of the remote
control.
5. Saving the remote control code:
hold down button A on the remote control until (you need to wait about 3 seconds) the control
unit indicator light activates with two consecutive impulses of about 100ms to indicate that the
control unit has correctly carried out the learning function and has exited this mode.