Crane BevMax 4 - Picker Cup at Wrong Location X Axis Flow Chart

44
Go to Factory Diagnostics.
Check encoder counts. Send to
home, does home switch light
come on?
YES
NO
Send cup to home
position. Does it go
home?
YES NO
Send cup to “E2-E8”
positions. Does it stop in
correct position?
YES NO
Is the horizontal
alignment correct?
YES NO
See X Axis
TS
Adjust Shelf
Offset as required.
See programming
Check Harness,
Keypad, Motor,
Board.
See XY not
working page
34.
Check Harness,
Keypad, Motor,
Board.
Do a Keypad test. Works?
YES NO
CUP AT WRONG LOCATION
LEFT /RIGHT or X AXIS
Repeat test at
several locations.
Does it stop in
correct position?
NO
YES
Close door, do a
test vend.
Change
Keypad.