Page 12 of 57
The Vender will support the following Domestic MDB Bill Acceptors:
All available CPI/MEI/Mars MDB
All available Conlux MDB
All available Cashcode MDB
All available Coinco MDB
The Vender will support MDB Card Readers.
The Vender supports Swipe/Tap for Cashless Vending.
“Select then Pay” workflow for purchasing product is also implemented for both Cash and Cashless operations.
SETTING THE TEMPERATURE CONTROL
This Vender is equipped with an electronic Encapsulated Temperature Sensor. Defrost is controlled both
electronically based on run time of the compressor and with a manual Defrost Thermostat. The Temp Sensor is
factory pre-set to maintain a cabinet temperature of 37º Fahrenheit (2.7ºC). It is also a good practice to ensure
the proper operating temperature prior to installing the Vender on location. To set the temperature, go to System
Settings > Refrigeration Settings > Refrigeration Set Point, and adjust the Refrigeration Set Point as necessary.
Press Accept to lock in any changes or Cancel to exit without making changes.
The manual Defrost Thermostat is located in the bottom left of the service area. The Defrost Thermostat is preset
and is not adjustable.
LOADING THE VENDER
CAN/BOTTLE DRINK TRAYS
The BevMAX Refresh 6 Media 5800-6/3800-6 Vender does not require spacers or shims to vend most packages.
Load product in each column one package at a time insuring that the package being loaded is in front of the
product pusher. Ensure that the package is stable within the column (doesn’t move excessively from side to side).
After loading the Vender, test vend each column to ensure proper operation. Please contact a Service
Representative or refer to the proper Technical Publication for any special settings you may need.
LOADING COIN CHANGER TUBES
Prior to placing the Machine in service, you must add an initial amount of change to the Coin Mechanism to
prevent a “Use Correct Change” condition. Initial loading of coins should be done with the steps below to ensure
the Coin Mech accurately counts all change available for payback to the customer. Recommended minimum
amount is $17.00 (1 roll each of 5¢, 10¢, 25¢ coins). This minimum amount of change should remain in the Machine
at all times.
To initially load the Coin Mech:
1. Enter the required PIN: 3333.
2. Touch the Monetary Menu Bar on the Screen.
3. Touch the Coins In/Out Menu Bar.
4. Increase the amount of Change Available by inserting coins thru the chute on the top of the Coin Mech.
Totals (count and value) for each coin should increase as coins are added.
5. Press the left arrow to exit and return to the Monetary Menu.
For additional information about the Coin Mechanism, refer to the manufacturer’s instructions.
To Next Page
Loading...
