Page 46 of 57
SELECTION WILL NOT VEND
Check Price, reset as needed.
Check Price, ensure credit is = to or
greater.
Check Gate & factory set up
recommendations for package.
Move product away from Gate and use Test
Vend to check Gate operation. Check for bent
pins. Use small amount of WD-40 on pins and
recheck. Replace Gate as needed.
Clean, lubricate, check for flash,
replace Slide Assy.
Check Harness connections at Atlas H Board,
Cup Motor Board, Port Board, X & Y Boards,
Use Vend Test to check Plunger arm,
replace Cup Assy. as necessary.
Check Cup Motor Board, Port Board, X & Y
Motor Boards Green status lights are blinking.
If only one is On or Off, replace the Off
To Next Page
