Page 7 of 57
CE Mark & IIA DECLARATION
An updated CE Mark or IIA Declaration document can be provided upon request: If needed please contact
Technical Support Manager in Williston, SC. Phone: 1- 803-266-5001 or email service@cranems.com.
PHYSICAL CHARACTERISTICS
Glass door width is 37.5” (95.25 cm) 5800’s, 28.1” (71.37 cm)
3800’s, height is 68” (172.72 cm) both.
INSTALLATION & SETUP
RECEIVING INSPECTION
DO NOT STORE THE VENDER OUTSIDE.
Upon receipt, inspect the Vender for any shipping damage. If there is any damage, have the delivery driver note
the damage on the bill of lading and notify Crane Merchandising Systems Customer Service. Although the terms
of sale are FOB shipping point, which requires the consignee to originate shipping damage claims, Crane
Merchandising Systems will gladly help if you must file a claim.
UNPACKING THE VENDER
Remove the stretch wrap, fiberboard edge protectors and corrugated front protector from the outside of Vender.
Do not store the Vender with stretch wrap on. Stretch wrap could
bond to the Vender’s surface, which could damage the finish.
Remove the shipping boards from the bottom of the Vender. The shipping boards are attached by the leveling
legs. To avoid unnecessary damage to the leveling legs or base, remove the shipping boards by using a 1-1/2 inch
or 38 mm socket type wrench to unscrew the leveling legs. Be sure to replace the legs after removing the shipping
boards. Once the skid boards are removed there is 3” (7.62 cm) from base flange to the floor with the leveling
legs screwed all the way in.
Once the Vender is unpacked, check the “200” Tray area for any additional parts, labels, or other information
concerning factory-equipped accessories such as Coin Mechanism, Bill Acceptor and Cashless Devices.
To Next Page
Loading...
