WARNING: TO AVOID THE POSSIBILITY OF A FIRE HAZARD, DO NOT STORE ANYTHING OR
ALLOW DEBRIS OF ANY KIND TO ACCUMULATE IN THE BOTTOM OF THE SERVICE AREA,
IN AND AROUND THE REFRIGERATION COMPARTMENT OF THE CABINET, OR IN FRONT
OF THE EVAPORATOR AND CONDENSER COILS.
WARNING: ENSURE THAT POWER IS DISCONNECTED
FROM THE VENDER BEFORE INSPECTING OR REPLACING
LAMPS, OTHER ELECTRICAL COMPONENTS, OR WORKING
WITH OR ADJUSTING THE VENDING MECHANISM. FAILURE
TO COMPLY WITH THESE INSTRUCTIONS MAY SUBJECT THE USER TO THE
RISK OF ELECTRICAL SHOCK OR MECHANICAL INJURY,
WHICH CAN BE SERIOUS OR FATAL.
ELECTRICAL POWER NEEDED
Refer to the Machine serial number plate to determine the correct voltage and frequency. In the US and Canada
this is 120Vac, 60Hz, 1P. In Europe, Australia, and other export countries, this is 220/230/240Vac, 50Hz, 1P
depending upon your country voltage. The serial plate also specifies the ampere rating of the Machine. This
Machine must be plugged into a properly rated receptacle with its own circuit protection (fuse or circuit breaker).
Equipment Nominal Power Requirements -
120V / 10.2 A = *1224W (1.224kw)
220V / 5.8 A = *1276W (1.276kw)
240V / 5.8 A = *1392W (1.392kw)
*Note: Watts = V x A
POWER SUPPLY CORD and GROUNDING REQUIREMENTS
In accordance with the National Electrical Code and Underwriters Laboratories Inc., Domestic Vending Machines
are equipped with a three-wire Power Supply Cord and Ground Fault Circuit Interrupter (GFCI). The GFCI device
is provided as part of the Power Supply Cord and is either incorporated directly into the plug or mounted on the
cord adjacent to the plug.
To Next Page
Loading...
