Creality CR-M4

9.Start Printing
16
Installation and use of the Creality Print slicing software
② Choose a language; ③ Choose a region;
④ Choose a model;
⑤ After the "Add Printer" is completed, adjust the basic
parameters through the printer "Management": the screen
size should be 480*800 and the preview image type should
be jpg, otherwise the previews cannot be generated;
Note: Previews cannot be generated when using other slicing
software;
Creality Print
① Download at
https://www.creality
cloud.com/software
-firmware/software
or find the software
on a USB flash drive
and install it;
M4
CR-M4
CR-M4
CR-M4
480*800
450 470
450