Product Manual — Doc. 7696D DGE-100 and DM-DGE-200-C • 11
Notes:
1. The COM and IR ports can be used for fully-customizable control applications via integration with a Crestron control
system with custom programming.
2. CEC may be utilized through either HDMI port for fully-customizable control applications via integration with a Crestron
control system with custom programming.
3. Manual switching and control port functionality on the transmitter require a control system with custom programming.
Control port functionality is not supported on DM-TX-4K-100-C-1G transmitters.
4. The DM-DGE-200-C supports up to two simultaneous streaming inputs with a maximum combined total bitrate of 25
Mbps.
5. When connected to a DM® switcher via the DM 8G+® input, the DM-DGE-200-C can obtain its LAN connection through
the switcher but does not receive an IP address on the switcher’s private network. Therefore, the device IPaddress must
be set on the customer LAN.
6. AirMedia® wireless presentation support requires a wireless LAN and the addition of an AirMedia gateway (sold
separately).
7. Web browsing, weather information, and certain other functions require an internet connection.
8. The maximum cable length for DigitalMedia™ 8G+ (DM 8G+) is dependent upon the type of cable, resolution of the video
signal, and capabilities of each connected device. Refer to the DM 8G+ Maximum Cable Lengths table in the
Specifications section for a detailed overview. Shielded cable and connectors are recommended to safeguard against
unpredictable environmental electrical noise which may impact performance at resolutions above 1080p. Refer to the
Crestron DigitalMedia System Design Guide for DM system design guidelines. All wire, cables, transmitters, and other
devices are sold separately.
9. The audio signal from any source connected to the HDMI® or DM input is passed through to the HDMI output without
processing, downmixing, volume control, or mute control.
10. The HDMI input signal cannot be downscaled more than 4 times. For instance, a 1920x1080 source signal can be
displayed no smaller than 480x270 pixels.
11. HDMI connections require an appropriate adapter or interface cable to accommodate a DVI or Dual-Mode DisplayPort™
signal. CBL-HD-DVI interface cables are available separately.
To Next Page
Loading...
Need help?
General