34 • DGE-100 and DM-DGE-200-C Product Manual — Doc. 7696D
Configuration
Prior to configuration, ensure the device is running the latest firmware. To update the firmware,
refer to Firmware on page 71.
NOTE:The PinPoint™ UX software functionality has been removed from the DM-DGE-200-C
as of firmware version 1.3781.000
xxx
. Prior to upgrading the firmware to this version or
later, the device must be taken out of PinPoint UX mode. If the firmware is upgraded while
the device is in PinPoint UX mode, the device must be restored or the firmware must be
downgraded to turn off PinPoint UX mode.
This section provides the following information:
l
Initial Setup on page 35
l
Local Configuration on page 40
l
Web Configuration on page 56
l
Perform a Factory Restore on page 83
To Next Page
