Crestron DGE-100 User Manual

Product Manual — Doc. 7696D DGE-100 and DM-DGE-200-C • 35
Initial Setup
Use the following procedures to set up the DGE following installation.
Access the Setup Screens
When power is applied for the first time, a splash screen is shown on a connected touch screen
display. Tap this screen to access the DGElocal setup screens for device configuration
(DM-DGE-200-C Setup screen shown).
NOTES:
l
The DGEmust be connected to a touch screen display to use its local setup screens.
l
The DGE may take up to two minutes to boot.
For more information on configuring the DGEusing its local setup screens, refer to Local
Configuration on page 40.
Access the Web Configuration Interface
The DGEmay be monitored and configured using its web configuration interface. The interface
can be accessed via the DGEIP address or the XiOCloud® service as described in the following
sections.
For more information on configuring the DGE using its web configuration interface, refer to Web
Configuration on page 56.

Crestron DGE-100 Specifications

General

Brand	Crestron
Model	DGE-100
Category	Engine
Language	English