Product Manual — Doc. 7696D DGE-100 and DM-DGE-200-C • 29
Observe the following when connecting the DGE-100:
l
Use Crestron power supplies for Crestron equipment.
l
If powering the device over PoE, a Crestron PoE injector (PWE-4803RU) or a Crestron PoE
switch (CEN-SW-POE-5 or CEN-SWPOE-16) is required. All PoE equipment is sold
separately.
l
Do not extend the included cable.
l
Connect the chassis ground lug to a known earth ground circuit (such as building steel) to
ensure that the device is grounded properly.
l
Apply power after all connections have been made.
To Next Page
Loading...
