Crestron Mercury CCS-UC-1 - Page 28

24 • CCS-UC-1: Crestron Mercury Tabletop Conference System Product Manual – DOC. 7844M
Use the following table and procedure to configure the device for Skype for Business.
Required Fields
USER is HOSTED BY SIP ADDRESS and USER
PRINCIPAL NAME (UPN)
REQUIRED FIELDS
On-premises
Skype for
Business Server
SIP address and UPN may be
the same
Username:
UPN or domain\username
Password
: Password
SIP Address
: SIP address
Office 365®
Application
SIP address and UPN are
traditionally the characters
before “@onmicrosoft.com”
Username
: UPN
Password
: Password
SIP Address
: SIP address
1. Set Enable to Enabled.
2. Refer to the table above to determine the required fields and configure the
Username, Password, and SIP Address fields as required.
NOTE: If the Office 365 account uses modern authentication, the login’s
password must be entered on the touch screen after the parameters have been
saved in step
6.
3. If automatic discovery for mobile clients hasn't been configured, enter the
following information:
− Internal Server Name:
https://webdir.online.lync.com/Autodiscover/autodiscoverservice.svc/
Root
− External Server Name:
https://webdir.online.lync.com/Autodiscover/autodiscoverservice.svc/
Root
NOTE: If these fields are left blank, the client uses autodiscovery. If the Skype
for Business deployment does not use autodiscovery, these fields should be
filled with the appropriate information.
These addresses are valid only for
Office 365 users and are different for On-premises Skype for Business Server
deployments.
4. The device can provide up to four speed dial entries. To configure a speed dial
entry, perform the following procedure:
a. Set Enable to Enabled.
b. Enter the “friendly” name of the speed dial entry in the Name field.
c. Enter the email address, phone number, or meeting URL in the Number field.
NOTE: The information entered in the Number field must be formatted for
the selected Type in step d below.