Page 15
INSTALLATION OF RX-40 RECEIVER
The PW16 is fully high level compatible with the RX-40 radio receiver. The addition of this receiver will add wireless
capability to your system in the form of wireless PIR detectors, Wireless Radio key transmitters and wireless reed
switch transmitters. The RX-16 receiver connects to the same communications port as the keypads and can be
installed , either inside the cabinet, or if preferred, may be installed at a remote location. The RX-16 is available in 2
frequencies, 303.875mhz or 433.92mhz. Multiple RX-16 receivers may be connected to the panel to increase the
effective range if required.
The RX-16 receiver requires 4 cores and can successfully be run in 0.2mm unscreened cable over a distance of up
to 100metres. Like the keypads the RX-16 has 12v and 0v terminals for connection to the 12v supply and CLK and
DATA terminals for connection to the communications bus.
The green LED fitted to the RX-16 receiver will indicate when the unit is in "Learn" mode (LED Flashing) or when it is
receiving an actual radio transmission (On Steady)
INSTALLATION OF VOICE or DTMF BOARD
The PW16 control communicator can also be fitted with a 90 second Voice Board or DTMF module. The Voice
board stores either alarm event messages for Voice dial monitoring and /or status messages for use with Command
Control. The DTMF board provides decoding of keypad numeric entries from a remote telephone. The Elite V6 Voice
or DTMF Boards are installed directly onto the motherboard via the "SERIAL" socket.
Installation procedure for the Voice or DTMF Board module is as follows.
1 Power-down the Elite fully before starting the installation procedure.
2 Carefully plug the Voice or DTMF Board into the SERIAL socket.
3 Power-up the Elite.
Once you have installed the Voice Board you can record your personalised speech messages into the module with
the speech programmer. The programmer plugs onto the 10 way strip connector on the voice board and must be
installed with the Brown wire towards the PW control board heatsink. Some programmers are fitted with a
polarisation pin on the connection socket which will prevent incorrect insertion however, some earlier units are not .
To record your messages once the programmer is installed, first press the reset button on the side of the Voice
Board, then hold the programmer about 10 cm away from the mouth and speak clearly at normal level into the
microphone while holding down the "REC" button. When you reach the end of your message release the REC
button. (NOTE: Each individual message must be longer that 2 seconds duration). When recording your voice alarm
message, you must ensure that you clearly identify the origin of the call. You can play the message back through the
programmer by first pressing the reset button then by pressing the "PLAY" button momentarily. Because the Elite V6
control communicator has the ability to store multiple alarm event and control voice messages, you must store
individual messages at what is known as recording slots within the Voice Board. These recording slots are recorded
sequentially, one message starting where the other finishes. Every time you press and release the REC button of
the programmer, you create an end of message marker. These markers are used to define the recording slots within
the Voice Board and can be of varying length according to each message duration.
To re-record a message you must first press the "RESET" button on the speech module to get back to recording slot
#1. Once you are at slot #1 you can re-record your messages in order as required.
NOTE: When recording multiple messages you only press the “RESET” button once at the beginning then record all
messages sequentially as stated above. When you have finished recording all of your messages you can then press
the “RESET” button to allow play-back of the recording messages for verification purposes.
When you have finished recording your alarm messages, unplug the programmer and the process is complete.
To Next Page
Loading...
