EasyManua.ls Logo

Crow PowerWave-16 - Programming Partition Parameters; Partition A Options; Partition B Options; Partition C Options

Crow PowerWave-16
85 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 26
Note: P492E through P498E are as above but apply to outputs 2-8 for Area C
PARTITION KEYPAD OPTIONS
PARTITION A -
P299E & P300E
PARTITION B -
P399E & P400E
PARTITION C -
P499E & P500E
P299E "ARM" key can disarm during exit delay - This option enables the one key disarm during exit delay
feature on a keypad by keypad basis with Partition boundaries . Options 1-8 represent keypads 1-8
P300E "STAY" key can disarm during Monitor Mode - This options enables single button disarm of Stay
mode via the "STAY" key. Options 1-8 represent keypads 1-8
Note: P399E & P400E are as above but apply to keypads in Area B
Note: P499E & P500E are as above but apply to keypads in Area C
PROGRAMMING PARTITION PARAMETERS
PARTITION "A" TIME ZONE AUTO ARM/DISARM OPTIONS -
P290E
PARTITION "B" TIME ZONE AUTO ARM/DISARM OPTIONS -
P390E
PARTITION "C" TIME ZONE AUTO ARM/DISARM OPTIONS -
P490E
P290E 1-8 Time Zone to use for Auto Arm or Disarm (Default 0) - This option will determine which Time
Zone/s will cause Area "A" to arm, disarm or both, based on the programmed options set at
P203E for Area A.
Note: P390E is the same as above but applies to Area B Time Zone Arm/Disarm
Note: P490E is the same as above but applies to Area C Time Zone Arm/Disarm
PARTITIONS TIME AND DELAY OPTIONS
PARTITION "A" -
P303E
PARTITION "B" -
P403E
PARTITION "C" -
P503E
P303E 1E Set partition when time zone ends -Default off
2E Unset partition when time zone starts - Default off
3E Disable stay mode exit delay - Default off
4E Disable set mode exit delay - Default off
5E Disable stay mode entry delay - Default off
6E Disable set mode entry delay - Default off
7E Use special stay mode entry delay - Default off
8E Send alarms and bypasses in stay mode - Default off
Option 1 Set partition when time zone ends - this option will automatically arm partition "A" when the
time zone programmed at address P290E finishes.
Option 2 Unset partition when the time zone starts - this option will automatically disarm partition "A"
Arm Key Disarms
1 2 3 4 5 6 7 8
- - - - - - - -
A Time Zones
A Misc Options 3
- - - - - - - -

Other manuals for Crow PowerWave-16

Related product manuals