Chapter 1 Introduction
1.7.16 FRM220-10G-SS 10Gbps 3R Fiber Transponder
The FRM220-10G-SS is a 10G fiber to fiber 3R repeater/transponder. Based on a number of 10 Gigabit Fiber
standards, this transponder supports SFP+ to SFP+ (SS) fiber connections. The transponders are protocol
transparent, providing 3R regeneration between these different optical module types. One of the major applications
for this converter is in connecting proprietary transceiver equipment to CWDM or DWDM when these 'colored'
optical modules are not available for the proprietary equipment. With full duplex wire speed forwarding capability
between the 2 fiber media, the FRM220-10G-SS brings you the best and simplest solution for your 10G conversion
between fiber and fiber.
Features
• Protocol transparent 3R fiber media transponder/repeater
• Supports IEEE802.3ae, 10G Fiber Ethernet
• Supports 10G Fiber Channel, STM-64
• Network management via terminal,
web or SNMP in FRM220-CH20 chassis
• Extend 10G Ethernet transmission over fiber
• Useful as a 'Transponder' in CWDM or DWDM systems
for 10G Ethernet/Fiber Channel/STM-64
• Supports Client / Line loop back tests
• Serial console for stand-alone management
when inserted in CH02M Two Slot Chassis
Specifications
Ports
Optical Interface
FRM220-10G-SS
Connector : LC, 1 Line SFP+, 1 Clien
Data rates:
1G FC (1.0625G)
2G FC (2.125G)
4G FC (4.25G)
8G FC (8.5G)
10G FC (10.51875G)
10G Base Ethernet (10.3125G)
STM-64/OC192 (9.95328G)
OTN G.709 OTU2 (10.709225G)
Loop back: Line/Client
Cable type : SM 9/125μm, MM 50/125μm, 62.2/125μm
Wavelength: 850, 1310, 1550nm (depending on SFP+)
LEDs Power, Line Link, Client Link, Test
Power DC In 12V
Power Consumption
< 8W
Dimension (D x W x H) mm 155 x 88 x 23mm
Weight 120g
Temperature
-10~60° C (Operating) ,-20~70° C (Storage)
Humidity 10~95% non-condensing
Certification CE, FCC, LVD, RoHS
MTBF
65,000 h (25° C)
Warning: Due to high power requirements and heat dissipation of 10G Series cards, they are limited to placing a
maximum of 10 cards in CH20 chassis leaving an empty space between each card. 10G Series cards should not be placed in
CH01 single slot chassis for this same reason. Additionally, only one card should be placed in CH02 with an additional NMC
for management.
This product includes the following models:
• FRM220-10G-SS (10G fiber 3R transponder/repeater, SFP+ to SFP+)
t SFP+
25
To Next Page
Loading...
Need help?
General
