CVT Drive and brake system
83
3. Slide the shift-shaft pillow block off of the shift
shaft. See Figure 6.86.
4. Remove the detent screw using a 1/4” allen
wrench.
5. Use a magnet, or turn the transaxle upside-down
to remove the detent ball and spring.
See Figure 6.87.
Figure 6.86
Shift shaft
Pillow block
Figure 6.87
Detent ball
Detent spring
Detent screw
Detent screw hole
6. Disassemble the brake:
6a. Unhook and remove the brake spring.
See Figure 6.88.
6b. Unbolt the brake yoke from the transaxle
using a 3/8” wrench. See Figure 6.89.
Figure 6.88
Figure 6.89
Brake yoke
To Next Page
Loading...
