Operating modes
A navigation announcement informs you
when y
ou ha
ve reached your “destination”.
A navigation announcement informing you
that you have reached the “destination area”
is given if the exact destination cannot be
reached.
During dynamic route guidance, you re-
ceive information about reported traffic
congestion on the route. An additional navi-
gation announcement is given if the route is
recalculated.
During a navigation announcement, you can
change its volume using the button .
For other announcement settings, select
Navigation > Settings > Navigation
announcements.
Note
●
If you miss a turning during route guid-
ance and are currently unable to turn back,
keep on driving until the navigation system
offers a new route.
●
The quality of the announcements and
recommendations depends on the naviga-
tion data available and any reported traffic
problems.
Route
In the Na
vigation main menu, press the
R
oute
function button.
The R
oute
function button is only displayed
with r
out
e guidance activated.
Function button: function
STOP GUIDANCE
: Aborts current route guidance.
ENTER DESTINATION
: To enter a new destination or a
new stopover
›››
page 197.
CONGESTION AHEAD
: To exclude a section of the route.
To cancel the exclusion, press the Route
function but-
ton and then CANCEL CONGESTION .
CHANGE ROUTE
a)
: The map of the calculated route ap-
pears and by holding a finger on the route and drag-
ging the finger across said map, the route is changed to
the road(s) that you want and the new route is then re-
calculated.
ROUTE DETAILS
: View route information.
a)
Only available for the model: Navi System Plus
My destinations (destination memory)
Fig. 164
List of saved routes.
The stored destinations can be selected
fr
om the
My destinations menu.
●
Press the My destinations.
function button
in the main Na
vig
ation menu.
●
Select the desired function button.
STORE POSITION
, ROUTES , DES
TINATIONS
,
LAS
T DES
TINATIONS
OR HOME ADDRESS .
St
or
e position
●
By pressing the STORE POSITION
function
butt
on, the curr
ent position is stored as a
Flagged destination in the Destination
memory.
To save the stored position permanently as a
flagged destination, change the name of
the position in the destination memory. Oth-
erwise, the saved position is overwritten
when another flagged destination is saved.
»
199
To Next Page
Loading...
