Start and driving
Emergency starting function
Fig. 198
On the right of the steering column:
emergency start.
If no valid key is detected inside the vehicle,
an emer
g
ency start-up will be required. The
relevant message will appear in the dash
panel display. This may happen when, for ex-
ample, the vehicle key battery is very low:
●
Immediately after pushing the starter but-
ton, keep the key next to the right trim of the
steering column
›››
Fig. 198, as close as pos-
sible to the Kessy logo.
●
The ignition connects and the engine
starts automatically.
Instructions for the driver on the in-
strument panel display
Press the brake
This message appears on vehicles with an
aut
omatic g
earbox if the driver tries to start
the engine without having the brake pedal
pressed.
Select N or P
This message appears if you try to start or
stop the engine when the selector lever of
the automatic gearbox is not in position P or
N. The engine can only be started and stop-
ped in those positions.
Engage position P; the vehicle can
move; doors can only close in po-
sition P.
For safety reasons, this driver message ap-
pears and an audible warning sounds if the
selector lever of the automatic gearbox is
not in position P after you switch off the igni-
tion. Move the selector lever to the P posi-
tion, otherwise the vehicle could move.
Gear change: selector lever in the
drive position!
This driver message is displayed when the
selector lever is not in the position P when
the driver door is opened. Additionally, a
buzzing sound is emitted. Put the selector
lever in position P, otherwise the vehicle
could roll away.
Ignition is switched on
This driver message is displayed and a buzzer
is sounded when the driver door is opened
with the ignition switched on.
“My Beat” function
For vehicles with a convenience key there is
the “My Beat” function. This f
eature provides
an additional indication of the vehicle igni-
tion system.
When entering the vehicle, the start button
›››
Fig. 197 flashes to draw attention to it.
When the ignition is on/off, the engine start
button flashes. With the ignition is switched
off, the start button goes off after a few sec-
onds.
With the engine running, the start button
light stays on, indicating that the engine is
running. The time elapsed between the mo-
ment the user starts the engine with the start
button button and the lighting changes from
flashing to fixed will depend on specific en-
gine size characteristics. When the start but-
ton is used to stop the engine, the button
starts flashing again.
In vehicles with the Start-Stop system, the
“My Beat” function also offers additional in-
formation:
●
When the engine stops during the Stop
phase, the light of the start butt
on button
»
229
To Next Page
Loading...
