Fuses and bulbs
–
T
urn the connect
or lock
›››
Fig. 52 in the
direction of arrow
1
and pull on the con-
nect
or.
–
R
otate the bulb holder in the direction of
the arrow
›››
Fig. 52
2
and extract it to-
g
ether with the bulb.
–
R
eplace the faulty bulb with a new identical
bulb.
–
Insert the bulb holder into the number
plate light and rotate all the way in the op-
posite direction to the arrow
›››
Fig. 52
2
.
–
Plug the connector into the bulb holder.
–
Insert the number plate light carefully into
the opening on the bumper. Ensur
e that
the number plat
e light is in the correct po-
sition.
–
Insert the number plate light into the
bumper until it audibly clicks into place.
Note
Depending on how equipped the vehicle is,
the number plate lights may be LEDs. LEDs
have an estimated life that exceeds than
that of the car. If a light with LEDs fails, go
to an authorised workshop for replace-
ment.
Side turn signals
Fig. 53
Turn signal integrated in the rear view mir-
ror
The side turn signals are LEDS and are inte-
gr
at
ed in the exterior mirrors.
In case of failure, go to an authorised work-
shop to have them replaced.
Additional brake light
Taking into account that it consists of LED
bulb
s, the chang
e should be made at a tech-
nical service centre.
59
To Next Page
Loading...
