Cupra ATECA - Page 60

Emergencies
Tail lights bulbs located in the rear lid
Fig. 49
Rear lid open: remove the cover.
Fig. 50
Remove the bulb holder.
The rear lid must be open to change the
bulb
s.
–
R
emove the rear lid cover in the direction
indicated
›››
Fig. 49.
–
Unlock the securing tabs from the bulb
holder
›››
Fig. 50
1
or turn the bulb hold-
er t
o the left
2
and
3
.
–
R
emo
ve the bulb holder from its location.
–
Lightly press the defective bulb into the
bulb holder, then turn it to the left and re-
move it.
–
Fit the new bulb, pressing it into the bulb
holder and turn it to the right as far as it will
go.
–
Use a cloth to remove any fingerprints
from the glass part of the bulb.
–
Check that the new bulb works properly.
–
Carry out the same actions in reverse order
for assembly and pay special attention to
placing the bulb holder, ensuring that the
tabs are properly secured.
Note
For LED pilots, you can only change the re-
verse bulb.
Changing the number plate bulbs
Fig. 51
In the rear bumper: Number plate light.
Fig. 52
number plate light: remove the bulb hold-
er.
Follow the steps indicated:
–
Press the number plate light in the direc-
tion of the arr
o
w
›››
Fig. 51.
–
Detach the number plate light.
58