Fuses and bulbs
For the sake of the environment
Please ask your specialist retailer how to
dispose of used bulbs in the proper man-
ner.
Note
●
Please check at regular intervals that all
lighting (especially the exterior lighting) on
your vehicle is functioning properly. This is
not only in the interest of your own safety,
but also that of all other road users.
●
Before changing a bulb, make sure you
have the correct new bulb.
●
Do not touch the glass part of the bulb
with your bare hands, use a cloth or paper
towel instead, since the fingerprints left on
the glass will vaporise as a result of the heat
generated by the bulb, they will be depos-
ited on the reflector and will impair its sur-
face.
Tail light bulbs located in the body-
work
Fig. 47
Luggage compartment: access to the bolt
securing the tail light unit.
Fig. 48
Retaining tabs on reverse side of tail light.
–
Check which of the bulbs is defective.
–
Open the rear lid.
–
R
emo
ve the lid, levering it with the flat side
of a screwdriver into the recess
›››
Fig. 47
1
.
–
Remove the bulb connector.
–
Unscrew the light securing bolt by hand or
using a scr
e
wdriver
›››
Fig. 47
2
.
–
Remove the light from the body, gently
pulling it t
o
ward you, and place on a clean,
smooth surface.
–
Disassemble the bulb holder unlocking the
securing tabs
›››
Fig. 48
1
.
–
Change the damaged bulb.
–
To refit follow the steps in reverse order,
t
aking special car
e when fitting the bulb
holder. The securing tabs must click into
place.
CAUTION
Take care when removing the rear light unit
to make sure there is no damage to the
paintwork or any of its components.
Note
●
Make sure you have a soft cloth ready to
place under the glass on the rear light unit,
to avoid any scratches.
●
In the case of LED lights, change only the
turn signal bulb.
57
To Next Page
Loading...
