Cupra ATECA - Page 58

Emergencies
In-line fuse Amperes
Rear power sockets 7.5
Fuse arrangement in engine compartment
No. Consumers/Amps
1 ESP control unit 25
2 ESP control unit 40/60
3 Engine control unit 15
4 Engine sensors 10
5 Engine sensors 10
6 Brake light sensor 7.5
7 Engine power supply 7.5/10
8 Lambda probe 10/15
9 Engine 10
10 Fuel pump control unit 15
11 PTC 40
12 PTC 40
13 Gearbox pump 30
14 Heated windscreen 40
15 Horn 15
16 Petrol pump 20
17 Engine control unit 7.5
18 Terminal 30 (positive reference) 7.5
No. Consumers/Amps
19 Front windscreen washer 30
21 Automatic gearbox control unit 15
22 Engine control unit 7.5
23 Starter motor 30
24 PTC 40
31 Pressure pump 15
37 Parking heating 20
Note
●
In the vehicle, there are more fuses than
those indicated in this chapter. These
should only be changed by a specialised
workshop.
●
Positions not containing a fuse do not ap-
pear in the following tables.
●
Some of the equipment listed in the ta-
bles below pertain only to certain versions
of the model or are optional extras.
●
Please note that the above lists, while
correct at the time of printing, are subject
to change.
Changing bulbs
Introduction
Full-LED headlights
Full-LED headlights handle all light functions
(da
ylight, side light, turn signal, dipped beam
and route light) with light emitting diodes
(LEDs) as a light source.
Full-LED headlights are designed to last the
lifetime of the car and light bulbs cannot be
replaced. In case of headlight failure, go to
an authorised workshop to have it replaced.
Rear incandescent light bulbs
Type
Turn signal PY21W LL
Reverse lights W16W
The remaining functions work with LEDs
CAUTION
●
Remove the ignition key before working
on the electric system. Otherwise, a short
circuit could occur.
●
Switch off the lights and the parking light
before changing a bulb.
●
Take good care to avoid damaging any
components.
56