EasyManua.ls Logo

Cupra ATECA - Page 68

Cupra ATECA
380 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operation
Indications of the compass
Depending on the equipment, when the ig-
nition is on, the instrument panel displa
y in-
dicat
es the direction in which you are driving
with a symbol, e.g. NW for Northwest.
When the Infotainment system is on and
there is no route guidance active, the graph-
ic representation of a compass is also shown.
Copyright
Legal text about the property rights and
copyrights of the instrument cluster.
WARNING
Even when the outside temperature is
higher than freezing temperature, some
roads and bridges could be frozen.
The “ice crystal symbol” indicates that
there may be a risk of freezing.
At outside temperatures above +4 °C
(+39 °F), there may be ice even when the
“ice crystal symbol” is not on.
The outside temperature sensor takes a
guideline measurement.
Note
There are different instrument panels
and therefore the versions and instructions
on the display may vary. In the case of dis-
plays without warning or information texts,
faults are indicated exclusively by the con-
trol w
arning lamps.
Some indications on the instrument pan-
el screen may be concealed by a sudden
event, e.g. an incoming call.
Depending on the equipment, some set-
tings and instructions can be carried out or
displayed on the infotainment system as
well.
If there are several warnings at the same
time, the symbols will be displayed one af-
ter the other for a few seconds. The sym-
bols will stay on until you remove the cause.
If when switching on the ignition warn-
ings are shown about existing faults, it
might not be possible to change the set-
tings or show the information as described.
In this case, go to a specialised workshop
and request a repair.
Instrument panel menus
The number of menus and information items
a
v
ailable will depend on the vehicle’s elec-
tronics and features.
A specialised workshop can programme or
modify additional functions, according to
the vehicle equipment. To do so, CUPRA
recommends going to a specialised CUPRA
dealer or any SEAT dealership.
Some menu options can only be read when
the vehicle is stationary.
Driving data
page 67
Assistance systems
Lane Assist On/Off
page 263
Front Assist On/Off
page 251
Blind spot detector On/Off
page 269
ACC (only display)
page 255
Navigation
Audio
Telephone
Vehicle status
page 68
Service Menu
In the Service menu various settings can be
adjust
ed depending on the f
eatures.
Open the Service menu
To open up the Service menu, select the
Range information profile while in the Driv-
ing data menu, and keep the 
key press-
ed on the multifunction st
eering wheel f
or
approximately 4 seconds. When it is re-
leased, the Service menu will be displayed.
Now you can browse through the menu us-
ing the keys on the multifunction steering
wheel as usual.
66

Table of Contents

Related product manuals