Cupra ATECA - Page 69

Instruments and warning/control lamps
Restart the service interval display
Select the Service menu and f
ollo
w the in-
structions on the screen of the instrument
panel.
Restart the oil service
Select the Restore Oil service menu and
follow the instructions on the instrument
panel display.
Restart journey data
Select the Reset trip menu and follow the
instructions on the instrument panel display
to reset the value.
Identifying letters on engine (LDM)
Select the menu Engine code. The identify-
ing letters of the engine will be shown on the
instrument cluster display at the bottom left.
Setting the clock
Select the Time menu and set the correct
time by turning the right thumbwheel of the
multifunction steering wheel.
Driving data indicator (multifunction
display)
The display of the travel data (multifunction
display) sho
ws different values about the
journey and the consumption.
Change from one display to another
●
Turn the right thumbwheel of the multi-
function steering wheel
›››
page 76.
Changing memory
While in Travel data > General infor-
mation press 
on the multi-function
st
eering wheel t
o switch between the 3
memories
1)
:
Since start: The memory is deleted if
the journey is interrupted for more than
2 hours.
Since refuelling: Display and stor-
age of the journey data and the con-
sumption values collected. When refu-
elling, the memory is deleted.
Long-term: This memory contains
travel data up to a maximum of 19 hours
and 59 minutes or 99 hours and 59 mi-
nutes, or up to a maximum of 1999.9 km
–
–
–
or 9999.9 km. When one of these val-
ues is exceeded (varies depending on
the version of the instrument panel),
the memory is deleted.
Delete journey data presets
●
Select the memory that you wish to erase.
●
Keep the 
button on the multi-function
st
eering wheel pr
essed for approximately 2
seconds.
Select the instructions
In the Infotainment system, in the menu Ve-
hicle settings, you can display different travel
data
›››
page 80.
Current consumption: The current
fuel consumption display operates
throughout the journey, in litres/100
km; and with the engine running and
the vehicle stopped, in litres/hour.
Average consumption: The average
fuel consumption is displayed after driv-
ing for approximately 300 metres.
Travelling time: This indicates the
hours (h) and minutes (min) since the
ignition was switched on.
»
–
–
–
1)
This will show all data on the display at the
same time: distance tr
avelled, average con-
sumption, average speed and autonomy.
67