Curtis 1239E - 5 - MONITOR MENU; BATTERY MENU; MOTOR MENU

5 — MONITOR MENU
Curtis 1239E-1269E Manual, os 37.0 RevA – May 2021
Return to TOC
pg. 76
5 — MONITOR MENU
rough its Monitor menu, the 1313 handheld and 1314 PC programmers provide access to real-time
data during vehicle operation. is information is helpful during diagnostics and troubleshooting,
and also while adjusting programmable parameters and the vehicle’s initial setup.
Table 4 Monitor Menu: 1313/1314 Programmer
INPUTS MENU................................. p. 77
— Throttle Command
— Throttle Multiplier
— Mapped Throttle
— Throttle Pot
— Brake Command
— Mapped Brake
— Pot2 Raw
— Steer Pot
— Steer Angle (deg)
— Interlock
— Analog 1
— Analog 2
— Switch 1
— Switch 2
— Switch 3
— Switch 4
— Switch 5
— Switch 6
— Switch 7
— Switch 8
— Driver 1 Input
— Driver 2 Input
— Driver 3 Input
— Driver 4 Input
— PD Input
— DigOut6 Input
— DigOut7 Input
— Switch 16
OUTPUTS MENU.............................. p. 79
— Analog Out
— Digital Out 6
— Digital Out 7
— Driver 1 PWM
— Driver 2 PWM
— Driver 3 PWM
— Driver 4 PWM
— PD PWM
VEHICLE MENU................................. p. 84
— Vehicle Speed
— Vehicle Odometer
— Vehicle Acceleration
— Time to Speed 1
— Time to Speed 2
— Time Between Speeds
— Time to Dist 1
— Time to Dist 2
— Time to Dist 3
— Braking Distance Captured
— Distance Since Stop
— Distance Fine
CAN STATUS MENU.......................... p. 85
— CAN Node ID
— CAN NMT State
— PDO1 RX Byte Map
— PDO1 TX Byte Map
— PDO2 RX Byte Map
— PDO2 TX Byte Map
BATTERY MENU.................................. p. 80
— BDI
— Capacitor Voltage
— Keyswitch Voltage
— Insulation Resistance
MOTOR MENU.................................... p. 80
— Motor RPM
— Max Speed Controller Limit
— Temperature
— MotorSpeed A
— MotorSpeed B
— Sin Input A
— Cos Input B
— Rotor Position
CONTROLLER MENU.......................... p. 81
— Current (RMS)
— Modulation Depth
— Frequency
— Temperature
— Main State
— EMBrake State
— EMBrake Test State
— Regen
— KSI Hour Meter
— VCL Error Module
— VCL Error
— PMAC Commissioning Status
— Motor Characterization Error
— Parameter Mismatch Error
— Supervision Error
— CUTBACKS............................... p. 83
— Motor Temp Cutback
— Controller Temp Cutback
— Undervoltage Cutback
— Overvoltage Cutback
— Battery Current Cutback
— MOTOR TUNING ...................... p. 83
— Motor RPM
— Base Speed Captured
— Test Field Current
— FOLL OWING ERROR -SPEED
MODE ........................... p. 83
— Following Error
— Following Error Timer
— PD Current
— 5 Volts
— 12 Volts
— Ext Supply Current
— Pot Low