Autocutter
1
Disconnect the power supply cable and
open the device cover (see paragraph 5.1).
2
Press the release button
and remove the front cover.
Clean the autocutter compartment from the outside
using compressed air.
Clean the autocutter compartment from the inside
using compressed air.
3
4
ATTENTION:
Do not use alcohol, solvents, or hard brushes.
Do not let water or other liquids get inside the machine.
To remove paper scraps, use tweezers or compressed air.
ON
Alcohol, solvent
Disconnect the power supply cable and
open the device cover (see paragraph 5.1).
93
To Next Page
Loading...
