Error 25 - Incline movement feedback stopped
Cause:
Incline is commanded to move yet the feedback indicates the value is not changing or ceases to change
as expected
Service:
• Bad or low battery, poor battery connection
• Incline motor’s lead screw requires lubrication
• Incline is binding
• Incline is hitting the low limit (the motor case) or the high limit (the weld washer), caused by the
calibration to be off or corrupted
• Incline is de-magnetized
• Incline motor brushes are worn, hanging up, damaged
• Potentiometer is damaged or the gear drive to it is worn or spinning on the shaft
• Fuse blown on controller
Page 71 of 202
Cybex 772A, 772AT Arc Trainer Part Number
To Next Page
Loading...
