The LED colors display intensity level.
LevelColorLED
LowYellow
MediumAmber
HighRed
Very highBlinking Red
Calf MuscleHamstring MuscleQuadricep MuscleGlute MuscleMuscle Map and
Incline Meter
An LED meter displaying the incline setting. The meter increase or decreases as
the incline changes.
Incline Meter
Setup
Use the following instructions to setup the unit.
1. Plug the optional power cord or E3 View Monitor power cord (E3 View Monitor units only) into a
power outlet from a grounded circuit.
Coil up the remainder of the power cord and place it out of the way. The control panel will light up
and be in the Dormant Mode.
2. Hold the handrails to steady self while stepping into the foot plates.
3. Begin striding.
Initial setup
Perform this procedure during the installation of the unit. Once complete, refer to Setup Options below.
Press and hold Cybex logo for 6 seconds to access
Screen Lock and Toolbox.
CYBEX LOGO
Page 24 of 202
Cybex 772A, 772AT Arc Trainer Part Number
To Next Page
Loading...
Need help?
General
