2. Plug the power cord into the power outlet.
The software will load into the console. This procedure may take up to 4 minutes. During the first
two minutes the screen will be blank and not show any progress. Do NOT turn the power off, press
any keys, or remove the USB stick. [re][bot].
After the initial period, the screen will display Loading and Please wait. This procedure may take
up to 2 minutes. When the upload is complete, the display will return to the home screen.
3. Unplug power cord from the power outlet.
4. Remove USB stick from internal USB port.
Install back cover
Install the four screws securing the back cover to the console assembly using a Phillips screwdriver.
Qty.DescriptionItem
1Console assembly1
1Back cover2
4Screws3
Complete update
1. Plug the power cord into the power outlet.
2. Operate unit at all levels to verify proper operation.
Calibration
Calibrate CardioTouch screen
1. Tap the Access Toolbox icon to display the Access to Toolbox login screen.
2.
Enter the sequence: .
3. Tap the OEM Diags icon, then the Touch Test icon.
4. Touch the CardioTouch screen to display cross hairs. If the CardioTouch screen is not calibrated,
the cross hairs will not line up where the touch is made.
5.
Tap the icon to return to the Diagnostics screen.
6. Tap the Touch Cal icon.
Page 91 of 202
Cybex 772A, 772AT Arc Trainer Part Number
To Next Page
Loading...
Need help?
General
