Perform Touch Calibration, Network Setup, or Channel Setup. See A/V
Configuration.
A/V Config
Set Default and Max workout times. Default choices are 20, 30, or 60 minutes.
Max choices are 20, 30, 60, or OFF.
Workout times
Set Pause time. Choices are OFF, 0:30, 1:00, or 2:00 minutes.Pause
Select console beeper settings. Choices are ON, Some, or OFF.
Selecting Some enables beeper for safety related notifications, such as En-
tering Active, Exiting Active, and Cool Down.
Sound
Select default language to display on CardioTouch screen. Toolbox is only
available in English. Include Optional Languages. Select optional languages
to display on CardioTouch screen. Choices are Include or Off.
Language
Exit Set Up Mode
Exit Set Up Mode by tapping the Toolbox icon, then tap the Home icon . The screen will
refresh.
Cybex GO Setup
Prerequisites:
• Coax cable with TV signal
• Netpulse Gateway installed and running, providing the connection via:
• Wired (Ethernet) – Ethernet cable is connected to the Cybex equipment through a network switch
to the Gateway
• Wireless – Gateway has been installed in the facility using a unique wireless access point. Cybex
GO Monitor will not connect to any other routers in the area.
• Power to the Cybex Equipment.
1. Install 6' coax cable to the coax cable connector in base of unit.
Qty.Description
16’ Coax Cable1
1Coax Cable Connector2
Page 26 of 202
Cybex 772A, 772AT Arc Trainer Part Number
To Next Page
Loading...
Need help?
General
