Error 26 - Incline disabled
Cause:
Incline feedback problems could not be remedied by re-calibrating after an Error 25.
Service:
• Bad or low battery, poor battery connection
• Incline motor lead screw requires lubrication
• Incline is binding
• Incline is hitting the low limit (the motor case) or the high limit (the weld washer), caused by the
calibration to be off or corrupted
• Incline motor is de-magnetized
• Incline motor brushes are worn, hanging up, damaged
• Potentiometer is damaged or the gear drive to it is worn or spinning on the shaft
• Fuse blown on controller
• Incline is unplugged or the cable is defective
Page 73 of 202
Cybex 772A, 772AT Arc Trainer Part Number
To Next Page
Loading...
