Error 38: Incline Timeout
Cause:
Incline is commanded to move yet the feedback indicates it has not reached the target within the allotted
timeframe.
Service:
• Incline motor’s potentiometer is physically rotated out of position
• Potentiometer is damaged or the gear drive to it is worn or spinning on the shaft
• Incline is hitting the low limit (the motor case) or the high limit (the weld washer), caused by the
calibration to be off or corrupted
• Fuse blown on controller or other controller hardware failure
• Check wiring from incline motor to LCB for nicks, shorts, opens
Page 82 of 202
Cybex 772A, 772AT Arc Trainer Part Number
To Next Page
Loading...
