D-Link DAP-1665 - Installation; What Mode Should I Use?

11D-Link DAP-1665 User Manual
Section 2 - Installation
Installation
You can simply connect a computer directly to the DAP-1665 with an Ethernet cable and then begin the conguration process.
For Access Point Mode, you may use an Ethernet cable to connect the DAP-1665 to your wireless router. (Refer to “Access Point
Mode Installation” on page 18.) You can also use WPS (Wi-Fi Protected Setup) for both the Wireless Client Mode and Repeater
Mode if your router has WPS. (Refer to “Repeater or Wireless Client Mode Installation” on page 18.)
The next section describes the ve function modes, and should help you decide which wireless mode to use. Then you can
proceed with installation and conguration.
What Mode Should I Use?
The DAP-1665 gives you a choice of ve operation modes, allowing you to customize the device to your networking requirements.
Refer to the following sections to determine which mode is best for you.
• Access Point Mode - page 12
• Wireless Client Mode - page 13
• Repeater Mode - page 14
• Bridge Mode - page 15
• Bridge with AP Mode - page 16