D-Link DAP-1665

53D-Link DAP-1665 User Manual
Section 3 - Conguration
Advanced
This section allows you to congure the advanced parameters of your DAP-1665. There will be dierent advanced features
available for conguration based on the mode in which your device is operating. The instructions below are listed according
to operation mode.
Congure MAC
Filtering:
Checkbox:
MAC Address:
Use the drop-down menu to select your preferred MAC ltering
method:
Turn MAC Filtering OFF - No MAC ltering will be implemented.
Turn MAC Filtering ON and ALLOW computers listed to
access the network - MAC ltering will be turned on, and only
MAC addresses listed in the table below will be allowed access.
Turn MAC Filtering ON and DENY computers listed to access
the network - MAC ltering will be turned on, and only MAC
addresses listed in the table below will be denied access.
Check the box to indicate this MAC Address should be included
in the MAC ltering rules.
Enter the MAC Address of the client that you wish to lter. If
the client is currently connected to the access point, you can
select it from the Client List drop-down menu, and click << to
automatically populate the eld.
Click Clear to clear all elds. Click Save Settings at the top of
the page to save the current conguration.
Access Point Mode
Access Settings
Mac (Media Access Controller) ltering allows you to control wireless access to your network according to clients’ MAC addresses.